Announcement

Collapse
No announcement yet.

Zero One Ads

Collapse

Dynatek BFG not priming??

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Dynatek BFG not priming??

    Hey guys,

    So this evening I went out for some pew pew and discovered one of my BFG's isn't priming, I pushed it down and the pin was pushed out as normal however would not then go back into allow the spoon down and then hold in place with the pin.

    No matter how far I pushed it down, pushing spoon in etc nothing helped.

    Had anyone had this before?

    If it's an internal problem has anyone opened one up before or know if any "how to" videos

    Thanks guys!

    John

  • #2
    Re: Dynatek BFG not priming??

    I had the same issue on one of mine. It was the brass jet nozzle that was blocked up and once I cleaned it out, it worked perfectly again.
    https://youtu.be/peR4TFyIJq4
    There's a video on how to dismantle the BFG, it was a bit of a pain the arse getting the top off as I found the hot water didn't make the casing soft enough to pop the top off, I ended up putting it in the oven at 100° for a couple of minutes which did the trick!
    . .

    Comment

    About the Author

    Collapse

    ginger_john Find out more about ginger_john
    Working...
    X