Announcement

Collapse
No announcement yet.

Zero One Ads

Collapse

Cylinder diameters - VSR/APS-2 or just weired

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Cylinder diameters - VSR/APS-2 or just weired

    Hi,


    I was wondering if someone can tell me below measurements about cylinder - are these for VSR or APS2?

    Cylinder: outer diameter 21.97mm,
    inner diameter of 20.02mm.

    Thanks!

  • #2
    Re: Cylinder diameters - VSR/APS-2 or just weired

    Hi,

    My calipers aren't as accurate as yours but that seems consistent with a stock APS2 cylinder. Are you trying to identify a mystery cylinder? If so the stem where the bolt handle fits is a much easier identify

    Comment


    • #3
      Re: Cylinder diameters - VSR/APS-2 or just weired

      Thanks,

      I am trying to guess the replacement cylinder for a japanese replica. I got dimension from a Japanese site.

      Unfortunately I don't have the cylinder itself.

      Comment


      • #4
        Re: Cylinder diameters - VSR/APS-2 or just weired

        I might have a destroyed aps2 one if you wanted to check? Is there a particular make that your looking at?

        Comment


        • #5
          Re: Cylinder diameters - VSR/APS-2 or just weired

          thanks for the offer, but I am not sure it's worth the shipping.

          If I'll decide to go for this replica, I'll make a post about compatibilities.

          Comment


          • #6
            Re: Cylinder diameters - VSR/APS-2 or just weired

            What is it if you don't mind me asking? The bolt stem and the little dimples for the bearings vary alot

            Comment


            • #7
              Re: Cylinder diameters - VSR/APS-2 or just weired

              It's a CAW. still wondering what will fit better.

              Comment


              • #8
                Re: Cylinder diameters - VSR/APS-2 or just weired

                You'd best check the cylinder head too! Both the thread dimensions and the length

                Comment


                • #9
                  Re: Cylinder diameters - VSR/APS-2 or just weired

                  You're right, cylinder and cylinder heads don't mix even for the same model.
                  I think I'll jump in for this project only if the price will really tent me as the risk to end-up with a wall hanger is too high.

                  Thanks for advice!

                  Comment

                  About the Author

                  Collapse

                  adrg Find out more about adrg
                  Working...
                  X