JG BAR 10 GSPEC problem

[sanborn]

when i pull my bolt back and then go to push it forward it wont go forward unless i hit it then it wont let me fire i have stripped the gun from cylinder to trigger mech and cant find any problems i have read that the cylinder rings could be missing and what not but mine are there and in good nic.

any help woould be brilliant.

cheers.

[sniper1982]

Re: JG BAR 10 GSPEC problem

Sounds like it could be a problem with the trigger return stop.

This is the bit that sticks up out of the top and has a small spring. Next to the trigger pull eyelet. Try and re-work this.

Remove the stock when cocking. The trigger stop should return upwards fully when the cocking lever is returned to firing position.

May also have to adjust trigger pull too.

Worth a try.

[RCW05]

Re: JG BAR 10 GSPEC problem

Try lubricating the piston in the cylinder well, make sure the trigger stop is working fully (watch it from the side), re - grease your sears, adjust trigger pull, check alignment of the cylinder inside the chamber. Get back to us if that doesnt help buddy.