Warrior L96 assembly help

[lc27396]

I recently bought a Warrior L96, however it was firing too hot, so I decided to disassemble it and put in a low powered spring.

When I came to do this, I took it apart fine, and thought I put it back together fine as well. This wasn't the case however, as now the bolt will slide back, but will not 'click' at it's furthest extent. This means that you can't cock the weapon.

Any ideas on why this might be happening?

[westywesty84]

Re: Warrior L96 assembly help

Did you take the trigger mech apart?

[lc27396]

Re: Warrior L96 assembly help

no...

(we think it might be to do with the cylinder)

[tisane]

Its going to be a pure coincidence.
Youve taken it apart and now id say one of the sears has gone.


Sent from my iPhone using Tapatalk

[lc27396]

Re: Warrior L96 assembly help

the sears look fine, no signs of abrasion.

[badas]

Re: Warrior L96 assembly help

Is the trigger mech pin in? Take it apart and put it back together again

Gd luck

[guard-sniper87]

Re: Warrior L96 assembly help

if the bolt is stopping when pulling it back , if yes the bolt pin is installed...
if it slides back normally but does NOT click into ready mode the sear is catching on the piston,

take the holding bolt pin out , and re align the bolt again and lube the bolt