VSR-10 piston, spring, cylinder area

[gezer]

Re: VSR-10 piston, spring, cylinder area

while opening the cylinder if scratched the head a bit thats why
dont want to buy new cylinder only cylinder head

[badas]

Re: VSR-10 piston, spring, cylinder area

Won't be a problem unless it's a deep cut internally

[gezer]

Ok will the laylax/pdi cylinder heads fit stock cylinder

[badas]

Re: VSR-10 piston, spring, cylinder area

my laylax one didn't

put up a picture of the damage and iel tell you if its unusable, as long as it screws in fine without cross threading then it should be fine unless the nozzle is damaged (holes or crushed)

[gezer]

The nozzle is faintly scratched from when I tried to use some tool on it (I'm 16 btw :facepalm
Lots of scratches on the rim (tuchin the cylinder) of the head were the vice and another tool has been used
Nothing serious but can put buyers off if I'm gonna sell it
Seen the Allen key way of opening it
But I just can't do it
Can someone say how to do it and I'll say if I did it right
Thanks

[badas]

Re: VSR-10 piston, spring, cylinder area

you just put yourself in it, your now allowed to own a BB gun...

[joshh1512]

Re: VSR-10 piston, spring, cylinder area

NONONO! Don't get the laylax hop unit, 1) you can't get the hop rubber for it on it's own, you have to buy a whole new unit, which may be a problem once it is worn down, 2) you can use a standard aeg barrel with it, but why would you want to do that? The laylax/pdi barrels are of better quality.

It doesn't matter if the nozzle is damaged, it's only aesthetic damage, shouldn't have any effect to the performance, although possible gives less air-seal when engaging with the rubber?

I also have some spare 90degree piston ends if you want them, though why would you want it? The laylax zero trigger comes with a 90degree piston...

And badas, possibly it is a two tone, which has been gifted too him? Though i somehow doubt you would have a two toned vsr, and be looking to upgrade it with a pretty high expense... hehe.

[gezer]

Re: VSR-10 piston, spring, cylinder area

you just put yourself in it, your now allowed to own a BB gun...

mum payed for it from z1
no money was given to her
so when i say mine i should really say mums (sorry about that)

can someone demonstrate the allan key cylinder head opening technique
as ive failed several times
a video would be good
thanks

[gezer]

Come on guys
Need help
Also I'm struggling to pull the cylinder
Ive only upped the spring to a laylax 120sp
Sears upgraded
Normal thing ?
Or something wrong
Thanks

[Vann8998]

Re: VSR-10 piston, spring, cylinder area

i would reconmend something very easy tbh.
take apart. CLEAN,LUBE, put back togeter. also are you sure your pulling the bolt back correctly? sorry saw a guy cycling the bolt horribly wrong few months ago and wondered why he was taking so long reloading lol