Help!!!!!

[JMusa]

i just disaaembled my ca m15a4 tac carbine and now one of the pins that goes into the lower receiver( nearest the stock) wont go in now it will go three quarters of the way in.

is this a problem
also how do i get it back in

[GH0ST]

Re: Help!!!!!

take it out and look through it, is it clear and perfectly allinged up ? if so try again but put maybe lil lube on the end. if this doesnt work try putting pin in the other side presuming you have it on the right side to start with?

[JMusa]

Re: Help!!!!!

ive tried all this and it doesnt look aligned correctly

[GH0ST]

Re: Help!!!!!

wiggle it about and see if that helps ? if not slide top off and see if there is anyreason to why it doesnt allign if there is no reason try a tent peg or something put through and try and wiggle till is alligned ? hope it helps

[JMusa]

Re: Help!!!!!

thanks

[TheLazyMarksman]

Re: Help!!!!!

James, I will post a pic if you tell me how to, I will show you what is should look like after you placed the body pin back into the body for your reference if you're still having trouble.

[JMusa]

Re: Help!!!!!

i know what its supposed to look like!! its just not happening

[Caveira]

Re: Help!!!!!

Sounds to me like the receiver is twisting slightly. Try flexing it as you put the pin in.

EDIT: Also, does the CA have 1 pin that's got a round head and one that's got a side that's straight? If so, are you using the correct pin?

[Renni 95]

Re: Help!!!!!

Happend to my a&k lr300 it looked straight but wouldent go further in than three quarters in.... hammer solved that problem

[TheLazyMarksman]

Re: Help!!!!!

Okay, try taking off the upper receiver and sliding it back, shine a light source through it and it should be a clear hole, then place the body pin back in.

[JMusa]

Re: Help!!!!!

iv tried with the hammer but ill try agauin

[TheLazyMarksman]

Re: Help!!!!!

Ah yes, like Comback said, it might need a bit of force to get in, I suddenly remembered I had this sort of problem, - don't do it too hard, if its not going in, don't force it! Its probably misaligned, do what I said above, it could be that.

[JMusa]

Re: Help!!!!!

done exactly what you said will but no joy

[TheLazyMarksman]

Re: Help!!!!!

Hmmm.... I have not a clue, try removing both pins, examine what could be stopping it and try again. Might need that little force for the pins.

[Renni 95]

Re: Help!!!!!

Another thing thats happend .... hit it with the hammer as far as itl go in then get some pliers twist it.. hit it ... twist it .. hit it .. might have bent it slightly