We 1911 barrel problem

[andy02380]

Re: We 1911 barrel problem

Hi the same happens on my WE Sig P228. Its extremely slight but noticeable now you've pointed it out. I can only assume it's where the outer barrel moves slightly in a up and down motion when the slide is pulled back. If your not happy take it into ZeroOne. They should be more than willing to have a quick look/put your mind at rest.


Sent from my iPad using Tapatalk

[scapula]

Re: We 1911 barrel problem

Yes it is fitted securely.. as you can see in the video the outer just literally moves backward a bit leaving the inner few centimetres up front.

Sent from my HTC One M9 using Tapatalk

[Wilko7]

Re: We 1911 barrel problem

Hmmm it doesn't seem right, have you taken the slide off and had a look of the inner barrel is fitted into the hop unit securely?


Sent from my iPhone using Tapatalk

[scapula]

Re: We 1911 barrel problem

Im not bothered about putting a silence but this seems odd thats why im getting paranoid if my airsoft is defective or something

Sent from my HTC One M9 using Tapatalk

[scapula]

Re: We 1911 barrel problem

Just not sure if the inner barrel will bump against the silencer's tip. (The threaded part that will go in the outer barrel)

Sent from my HTC One M9 using Tapatalk

[Wilko7]

Re: We 1911 barrel problem

That would be a decent upgrade. Get a longer tightbore inner barrel, and a silencer and run the barrel through the silencer. Should increase FPS and accuracy. Only problem is you will not be able to remove the silencer as the inner barrel will stick out by a couple of centimetres


Sent from my iPhone using Tapatalk

[scapula]

Re: We 1911 barrel problem

So is this normal?
Thanks

Sent from my HTC One M9 using Tapatalk

[Wilko7]

We 1911 barrel problem

It shouldn't effect the silencer mate, the hole of the silencer should be big enough to fit a longer barrel hidden within it.


Sent from my iPhone using Tapatalk

[scapula]

Hi.
So i got this airsoft gbb from zeroone
We 1911 GBB. I have only noticed now. That when you pull back the slide. The external barrel goes with slide back and the internal barrel goes upfront. The internal barrel does not go externally out or farther than the external barrel which is fine.

But im thinking if I put a silencer, will it stop the slide from pulling back as the internal barell will bump against the silencer threaded tip?

Is this normal? If not how do I fix it!!?

Ive also tried holding firmly the external barrel from the shell ejection port (to prevent the outer barrel from going in with the slide) and try to push back the slide but the slide wont move while holding it firmly.

I have a short video to show what im mean Here is the link:
https://youtu.be/-m4JBVMOAYw

Let me know if the link does not work.





Sent from my HTC One M9 using Tapatalk