mp5 'ris/ras'

[joshh1512]

Hey, so i got my mp5, it's a TM one, got it on here and it came pre-installed with a rail system...

Anyway, it also comes with a scope mount, however it looks like this may be a main part of holding the rails together?

Is there a way of removing it has i want to put a top rail claw mount and a red dot on instead of an aimpoint...

cheers, pics can be taken if needed.

[kejot]

Re: mp5 'ris/ras'

if its the bolt on one, just remove it and refit the bolts in the side, sounds like the mp5 navy, put few pics up to check

[sparrowhawk]

Re: mp5 'ris/ras'

sounds like a cyma ris,its the one where you cant fit a battery in the front end, your mp5 is a full stock right? as above,just take it off,but i would recommend a shorter bolt

[joshh1512]

Re: mp5 'ris/ras'

It's the full stock version, the guy who i bought it off says its a g&g one, but i doubt that very much, as for attaching it, it bolts onto the front, and then at the rear, there are two small screws for each side, and a plate which goes on the inside of the ris, but without the scope mount, this ris bends out?

[sparrowhawk]

Re: mp5 'ris/ras'

if its G&G it would be written on it.....