cant get the hop spacer back in

[chris wheeler]

hey caant get the hop up sccaper back in the gap. anyway of easliy doing this?

[B.E.N.]

Re: cant get the hop spacer back in

Please elaborate.

[chris wheeler]

Re: cant get the hop spacer back in

small peice of rubber has came out of my hop. (the peice that is pushed to apply hop to the bb. i can get it back in as when i put it in it rolls out the other end of my hop chamber

[ThePope]

Re: cant get the hop spacer back in

Take apart your hop, stick the nub on the arm put your hop back together, piss easy to do with pretty much any hop unit (I guess you are on about an M4 unit)

[chris wheeler]

Re: cant get the hop spacer back in

cheers mate, yeah m4

[ThePope]

Re: cant get the hop spacer back in

Yeah, piss easy to take apart, if you have any silicon oil it helps keep the nub on the arm, if not just make sure you have a steady hand lol.

[ste887]

Re: cant get the hop spacer back in

put silicon grease on the nub arm, it holds the nub in place

[B.E.N.]

Re: cant get the hop spacer back in

Alternatively, wind the hop off fully, place the nub in the cylinder and carefully roll it into place with a small screwdriver or similar...

[ThePope]

Re: cant get the hop spacer back in

Alternatively, wind the hop off fully, place the nub in the cylinder and carefully roll it into place with a small screwdriver or similar...

I can never get it to roll in properly

[B.E.N.]

Re: cant get the hop spacer back in

I can never get it to roll in properly

I guess there's a knack to it...

[chris wheeler]

Re: cant get the hop spacer back in

Alternatively, wind the hop off fully, place the nub in the cylinder and carefully roll it into place with a small screwdriver or similar...

this is what i tried but its freiking impossible

[guard-sniper87]

Re: cant get the hop spacer back in

get a small thin pin, pierce one side ,

unwind the hop fully , slide into the slot , then use a screw driver ontop of the hop nub to hold it in place then pull the pin out , easy