Carrying M203 shells

[OllieHolmes]

How do people carry their loaded M203 rounds? I did look at just a normal pouch but then i realised the grenades have to be kept upright or the bbs all escape.

I did some googling and found the Eagle Industries leg holster thing but id prefer them on my chest.

Would one of these take them?
http://www.zerooneairsoft.com/produc...roducts_id=465

Ooops forgot to mention my tac vest has lots of loops on it and the current pouches aresecured by long narrow straps with poppers.

[tyreal]

Re: Carrying M203 shells

My solution is the Tactical Tailor 40mm grenade bandolier. Keeps them handy and holds up to 12.

[Sci Fi Steve]

Re: Carrying M203 shells

203 should have a O ring in them to stop the bB's falling out........ I have a Tac Tailor bandoleer as well

[OllieHolmes]

Re: Carrying M203 shells

203 should have a O ring in them to stop the bB's falling out........ I have a Tac Tailor bandoleer as well

Ive got a new ICS 36 round shell and cant see any.

[Sci Fi Steve]

Re: Carrying M203 shells

they should be set in each tube just above the hight of the BB capacity

[BALBOSA]

Re: Carrying M203 shells

best way to check is fill em to the top and shake it upside down if theirs an even amount left in the tubes then the o rings working. as for carrying them i just use a cheapy grenade pouch attached to my vest works wonders and if you did have probs keeping them in then you can put them in bottom first and the strap closes tight over the holes

[ZX12R A1]

Re: Carrying M203 shells

40mm molle pouch made for the job is the best method

[OllieHolmes]

Re: Carrying M203 shells

they should be set in each tube just above the hight of the BB capacity

I did think it was slightly odd they didnt stay in. I will upload some photos later.

[PKR]

Re: Carrying M203 shells

i have 40mm grenade molle pouches with the strap over the top so if they accidently go off in the pouch im not gonna lose my face

[ste887]

Re: Carrying M203 shells

I did think it was slightly odd they didnt stay in. I will upload some photos later.

just clingfilm over the ends, when you fire the bbs just break through the film

[cool-breeze87]

Re: Carrying M203 shells

You need to load them by hand, speedloaders don't work for some reason. That could be one of the reasons for them falling out.

[Froggy]

Re: Carrying M203 shells

I tend to use a speedloader (couple of pumps for each tube works pretty well in mine), then use the 'reset rod' I've made (hex key taped to a elastic keychain >.>) to push them down into the holes.

The rubber ring that holds them in does sit just below the top, so a few do fall out, but there's still plenty in there to make a very nice bang :D