cyma glock feeding help

[humphriesryan]

right i have a glock i got in a swap but it works when dry firing...... but when i have bbs in it fires baybe 1 then does not feed nor on full auto ........ i have tryed pushing the mag up but still nothing


can u help

[Phatvortex]

Re: cyma glock feeding help

Had this issue. Mine was the mags.

Try lubing up the followers.

[humphriesryan]

Re: cyma glock feeding help

Done tht and nothing

[Phatvortex]

Re: cyma glock feeding help

Do the followers in the mag actually push the BBs up?

[humphriesryan]

Re: cyma glock feeding help

I guess so there is no way to no

[Phatvortex]

Re: cyma glock feeding help

I'm guessing this is with the long mags then.

Pop the slide off and check the nozzle assy is moving properly.

[humphriesryan]

Re: cyma glock feeding help

Done tht an its fine .....oh and its the standard not hi cap mag

[Phatvortex]

Re: cyma glock feeding help

90% on the mag. Try only filling it a little bit, 5-10bbs or so.

[humphriesryan]

Re: cyma glock feeding help

Done tht an still nothing ... even took apart and cleaned and no obstructions..... and I also think its the mag ... I have a new one on its way so ill test tht and see lol if that don't work then I'm stumped as I've done every thing I no, witch is the same to wat u said ......

I even mag shore tht the top of the mag is def mateing proply with the hop unit witch it is

[ollywallybingbong]

Re: cyma glock feeding help

I think you might have a problem with your hop rubber pal. The hop unit is piss poor to say the least. It doesn't quite line up with the barrel, and the way the unit clamps together a causes the rubber to form an oval. I've had this problem before, as well as double feeding. Both times were after I cleaned the barrel. I couldn't see any obvious defects to the rubber itself, but after stripping the unit and putting it back together again, it fired fine.

[humphriesryan]

Re: cyma glock feeding help

Ok ill try but I took it apart and still did the same ... so should I loosen the screw on the unit so it don't clamp it to tight ??

[humphriesryan]

Re: cyma glock feeding help

Checked the rubber made sure its not clamped to hard and tht ..... but still happening