Need advice and opinions on a current project im building

[RMcommando1984]

Im building a L129a1 AEG,
Ive built all the externals from parts i had already,
Ive only ever owned PTW's or GBBR's so im a little naive to what internals i need as im after PTW performance or as close as i can get to one,i want the best hop/inner barrel for range,ultimate trigger response,etc and it needs to fire at 350 fps all together!
The gun is based on a SR25 Body so 7.62 long body and 16inch barrel,semi only if i can and rear wired to run off a 11.1 lipo with deans,
I need some advice from you guys to what parts you would use to build the ultimate/best internal AEG ! in not on a particular budget so cost is not an issue !

So no arguing with each other like all the other posts just your advice please

What parts would you recommend then guys ?
copy/paste and fill out below if it helps ?


Gearbox shell :
Gears :
Gear ratio :
Bushings/Bearings :
Cylinder :
Piston :
Piston head :
Wiring
mosfet :
tappet plate :
spring :
air nozzle :
motor :
Hop chamber :
hop rubbers :
inner barrel :
any other parts ive missed ? :
Ammo you would recommend :

Someone thats good at building gearboxes ! :


Thanks.

[sj_asc]

Re: Need advice and opinions on a current project im building

What GB are you basing it on? The SR25 can take 2 types of shell.
There's one standard V2 with a hugely long nozzle or an SR25 specific Long type V2 which accepts the larger PSG-1 cylinder?

[Crude Skinny B]

Re: Need advice and opinions on a current project im building

money no object

Shell: lonex 8 mm
Gears :Siegtec gears 14:1
Gear ratio :14:1
Bushings/Bearings :terminusx 8mm bushings
Cylinder :stock, highly polished
Piston :shs 14 tooth, or lonex red piston
Piston head :a polycarbonate one, I like element
Wiring:
mosfet :I would say the ascu, but hate the thin wiring, a Extreame fire MOSFET, your choice of version
tappet plate :shs or lonex, lonex if you go with the shell
spring : depends on short stroking as I'm going for a high rof fast trigger response idea but as its semi only not exactly sure and plus a long barrel, personaly I would, and would be 3-4 teeth ss matched with a m130 and tuned to 350, (my usual build combination) for make, I use shs
air nozzle :shs paired with shs cylinder head or lonex, but from one brand
motor :lonex a2, element high torque, shs high torque in that order
Hop chamber :madbull
hop rubbers :r hop with guarder rubber
inner barrel :promy 6.03 barrel
any other parts ive missed ? :
Mods:
Swiss cheesing
Aoe correction
Short storoking, maybe?
11.1 lipo deans
Well shimmed
Ammo you would recommend :I use blasters, 0.28, but I would experiment

[RMcommando1984]

Re: Need advice and opinions on a current project im building

Thanks for that crude,
I think ill base the gearbox on a long v2.

[RMcommando1984]

Re: Need advice and opinions on a current project im building

Anyone else got any advice they dont mind sharing ???

[RMcommando1984]

Re: Need advice and opinions on a current project im building

Anyone ???
i also need to find someone who can build it for me ???

[blytm]

Re: Need advice and opinions on a current project im building

Anyone ???
i also need to find someone who can build it for me ???

http://www.zerooneairsoft.com/