Mad bull blue hop rubber in ics

[HEXAS]

Has anyone ever had problems with mad bull blue hop rubbers inside ics hop units.

Iv tryed again and again today and can't get it to seat right, I'm thinking maybe there not compatable.

[sharpy]

Re: Mad bull blue hop rubber in ics

I have them in all my ics guns and all have madbull barrals and rubbers.
Make sure you put sylicone on the out side to help it seat in propperly

[HEXAS]

Re: Mad bull blue hop rubber in ics

Cheer buddy, yeah it was all lubed up just didn't go in right that's all.

I'll try again tomorrow

[Sir Stephen]

Re: Mad bull blue hop rubber in ics

make sure to trim 1-2mm off the end of it, they are a bit long

[Mickydoos]

Re: Mad bull blue hop rubber in ics

Is it on a mad bull barrel? I've heard that the outer diameter of them is ever so slightly smaller as the rubbers thicker. Do take a bit off the end as said. I struggled to get the c clip back on without

[jonny lovegrove]

By a bit id (cut) take it to about halfway between the end and the nub. Itll go in fine then.

[HEXAS]

Re: Mad bull blue hop rubber in ics

Yeah that's what I had to do in the end fellaz, as said it was to long.