unmarex g36 not firing properly HELP

[mason storm]

just replaced broken tappet plate but now gun cycles fine but bb's just fall out end of barrel have checked gearbox again everything in place
any ideas as i have none thanks

[sj_asc]

Re: unmarex g36 not firing properly HELP

How so was the tappet plate broken?
A small list of more likely problems that could cause the air loss.

*Air-seal nozzle damage
*Hop bucking damage
*C-Clip on the hop chamber loose (allowing inner barrel to move)
*If you have a ported cylinder was it installed backwards?
*Tappet plate's resting position - some brands have poor QC and some are off spec, if it doesn't seat farther forwards enough you will loose seal.
*Chamber seating - It should be sprung against the front of the gearbox.

[mason storm]

Re: unmarex g36 not firing properly HELP

it was tappet plates resting position all sorted many thanks