Front wiring into an G&G M4 RIS - possible?

[Scholesy]

Hi everyone, I have a Madbull ACE stock to fit onto my m4: socom small.jpg

Issue is, the Lipos that will fit in a stock tube are silly small, and the wiring in there looks like it'll be an absolute nightmare.

Is it possible to fit batteries inside a G&G combat machine front RIS, has anyone done this? It looks like it will be quite a close fit but g&g have their own funky slim outer barrel on my gun (the RUSH),
so there is likely more room than other manufacturers m4's.
If not I will have to go with the old school M4A1 front end, then I can just run it on the cranestock NiMH I currently use in my existing stock.

Thanks for looking, hope someone can chime in on this!

[jonny lovegrove]

Frontwire into a PEQ?

[Menashem]

Re: Front wiring into an G&G M4 RIS - possible?

PEQ FTW! What I've done. Got a ris already, so stick a box on the side.

[Scholesy]

Re: Front wiring into an G&G M4 RIS - possible?

Yea I've been staring at pages of peqs all night trying to figure out what would work, could you guys please show me some photos of your peq setups? And some specs (what size LiPo you are using in said peq, do you use mosfet with it etc)?

I have a lipo ready charger but haven't tried them yet, do Lipos last longer than an equivalent mah capacity nimh? IE: 7.4 20c 1600 lipo vs 8.4 1600 nimh - which will last longer shot for shot?