ICS M4

[Barlow]

Ok so this isn't exactly a major problem but it is getting on my nerves.

So I've just got an ICS M4 from a swap, the gun is fantastic and everything internally so far has been sound. The problem I am experiencing is the outer barrel assembly is a bit loose. Basically the sight at the front can rotate a few millimetres left and right and it's quite irritating. I've taken off the front hand guard to have a look and the barrel up to a certain point does not move at all. It's only where the front sight connects that the problem begins.





Any help would be appreciated cheers

[Bullet]

Re: ICS M4

Is it a one piece barrel?? Or it it 2 sections screwed together??

[sureshot24]

Re: ICS M4

its 2 sections screwed together the front screw is just needing tightened buddy.

[Bullet]

Re: ICS M4

Thats what i too was assuming!!^^^^^^^

[Barlow]

Re: ICS M4

That's the problem I can't find the screw heads to tighten them, unless it's the little hollow things underneath but how would I tighten them?

[sureshot24]

Re: ICS M4

it is man small allen key is required.

[Barlow]

Re: ICS M4

Alright mate, I don't think iv got an allen key that small. Need to try and get a hold of one, cheers man

[Barlow]

Re: ICS M4

Found an allen key that fits mate, got it sorted! also, you have a pm inbound