Mosfet help

[guard-sniper87]

Please help me guys,

im after a mosfet for my armoury's rifles to look after them a little better

right ,

main guns im wanting one for are

MP5sd5 - rear wired on lipo (7.4 2200 25c)
GR16-EBB- Front wired on 8.4 1600 nimh
MASADA - front wired on lipo (7.4 4000 35c and 11.1 1650 30c )
and maybe my new TM sopmod

right the sort im after is a mosfet that is programmable pref with three shot on one pull then hold for full auto,
active breaking to stop over spinning and to decompress the spring and piston posistion
added trigger sesitivity making it more a pdw


i have a budget of about 50 quid for one

i have a ptw acu switch, that one is going in my other masada and i know the one im after wont compare to this, and not expecting it to...

just after one ..

please help , suggestions needed

[sparrowhawk]

Re: Mosfet help

fireworksairsoft has a programmable mosfet called an ARES, that is a clone of the extremefire long...and its £45...ive pmed you the link

[guard-sniper87]

Re: Mosfet help

cheers mate , will have a lookk into it ,

and will be looking into getting this week after sunday

[sparrowhawk]

Re: Mosfet help

actually the extreme fire long does not have the programmable features that the fireworks one has....the extreme fire that is programmable was the evolution, but that has been replaced with the cheetah ,which is based on the panther platform...its all a bit confusing....just buy the fireworks

[guard-sniper87]

Re: Mosfet help

ok bit of a snag when the masada comes into mind and the m4

due to the front wired design , as they are spade connectored so you can remove the plug end before going into the gear box ,

will it be possible to put these same spade connections onto the mosfet's

so there will be three spade connections one on each wire, red. black then the mosfet's other coloured one or will this ruin the mosfet

[Xiosis]

Re: Mosfet help

I think I know what you mean, I have a fireworks 3 round mosfet in my kwa and my tech has added spade connectors to allow the mosfet to be removed if the top reciver needs removed.

Hasn't effected the MOSFET at all. I can try and get some pictures if it's any help.

Cheers, Steve

[guard-sniper87]

Re: Mosfet help

yeah please mate, that would be much helpfull