G36 hopup advice

[Daredevilxp9]

I recently purchase a JG MG36 (so just a G36 with a c mag and bipod) and have only fired about 700 rounds but the hop up wasnt all that brilliant i dont think (or i'm being far too gentle and not cranking it up enough) saw a TM unit on zero one, wondering if that would be the WHOLE hop, everything included or if i would need anything else.
Also any other advice of what I should I do instead of buying another hop maybe?

http://www.zerooneairsoft.com/produc...oducts_id=2979

[Montesa77]

Re: G36 hopup advice

Just buy a Guarder/TM rubber. No need getting a new hole unit.

[Daredevilxp9]

Re: G36 hopup advice

mmmmmm
how fiddly is it to replace the rubbers?
cuz i did my first take down today, all except the gearbox came out as the last pin just wouldnt shift, and the hop looks a bit fiddly and important:P

[Montesa77]

Re: G36 hopup advice

Easy! Just don't loose the nubbin.

[Daredevilxp9]

Re: G36 hopup advice

hmmmm i feel some reading on the internet coming up

[ElCarl]

Re: G36 hopup advice

Easy! Just don't loose the nubbin.

This. Very easy, just don't lose the nub! Or the c-clip. Guess how I made my SRC G36c completely useless? Yep. However, it does serve as an excuse to finally do that upgrade I've been lining up for it - new rubber, nub and barrel.
Also I've heard you need to be careful when pulling the rubber off, as they can tear. For me, when I was fiddling around, it slid off easily... But if you're replacing it, you might not need to keep it