CYMA Ak47 0.28

[Silicon]

Hey folks i need a bit of help asap im hoping to buy this gun tonight.

Its a Cyma Ak 47 0.28 but theirs an issue the selection plate for a Safe mode - semi/full auto is gone its been broken off.
i need to know wether i can just get a pair of plyers and put them over the black bit you see on the picture below, were the plate usto be and twist it to turn it into Fully Auto Mode and jut leave it on that ?.



Heres a link to the gun im buying in the forums

http://www.zeroin.co.uk/showthread.php?t=14060



Thanks

Silicon

[Fluxeor]

Re: CYMA Ak47 0.28

You probably can lock it in full or semi using that method, or you can replace the selector switch (King Arms do a reinforced version for $40 you can find on Airsoftgi and there are other cheaper replacements on other sites, if you do a bit of searching)

[Caveira]

Re: CYMA Ak47 0.28

Should be an easy replacement.

But, check your site will allow ex-2 tone. I couldn't use that where I play!

[Silicon]

Re: CYMA Ak47 0.28

kk , is there any way they can tell if i sand EVERY part of the 2 tone off ? lol