TM Mac10 motor help

[Andyajc]

Hi Guys

A tab on my TM Mac10 has sheared off some how.

Ive tried everywhere to get a new motor , but it seems they dont have any anywhere.

Can anyone point me in the right direction???


Thanks

[ste887]

Re: TM Mac10 motor help

you could solder the wire on, or dissasemble the motor and get a piece of copper and glue it to where the contact was then connect up as normal

[richardy]

Re: TM Mac10 motor help

I have some aftermarket ones.. as long as its the same size as the AEP motor in length and diameter.

If you could meassure it please and let me know.

[Andyajc]

Re: TM Mac10 motor help

The arm that comes out from the motor is about 17mm long.

The motor is 30mm long and 24mm wide.

I tried you Rich at eagle 6.

When you getting sopmod parts back in mate???

Im wanting loads off you :D
I was one of the first buyers of the original lipo's and its still going strong , but i want the new one , gold contacts & a service.
I was going to send the gun down last month with the mosfet , but i was told you cant fit them in the sopmod so i was hoping to send it down for all the other bits. I also want 8 lo cap mags.

Sorry to go off subject

[richardy]

Re: TM Mac10 motor help

if you wait 1 month we will have specifically designed mosfets for the sopmod series not to mention a hopefully cleared back log of repairs.

The motors i have here for the aeps will fit the hole 30mm by 24mm BUT the shaft is only about 10mm long i normally cut it it length for the aeps.

[Andyajc]

Re: TM Mac10 motor help

Ill still take one if thats ok mate.

If the diameter is similar ill open it up and use these internals , worth a try.

How much?

[richardy]

Re: TM Mac10 motor help

pmed