Fuse removal for Mauri G36C?

[jsjpop]

Hi guys, I have a Mauri G36C and I want to install a large handguard so that I can fit in a 8.4V large battery or a 9.6V large battery.

My only concern is that will the increase in voltage and current due to higher voltage battery blow up the original fuse?

[jagillham]

Re: Fuse removal for Mauri G36C??

My fuse went within about 30mins of putting in a 9.6v battery. Just bypassed it and ran fine for months. Eventually put back the 8.4v as the ROF was stupid with the MOSFET & GP120 Motor. Must be 9 months now without fuse, and no problems yet!

[Ells]

Re: Fuse removal for Mauri G36C??

ah i can see you helping me out here as well jag, what fuse rating would you recommend for running on a 9.6v with mosfet & capacitor bank, not sure if those make any difference though, but cheers anyways.
running on a guarder sp110 as well, should probably mention that.
Ells

[sj_asc]

Re: Fuse removal for Mauri G36C?

The stock Marui setup should not pop a fuse with a 9.6v.
What battery are you using? Make, capacity etc..? (ells)

[Ells]

Re: Fuse removal for Mauri G36C?

will be a ********* **** 9.6v 1500mah w/ deans
can list internals if thats needed as well?