v3 Tappet Plate Issue

[vortex]

Hi,

Quick question!

I have a new Systema v3 tappet plate for my aug but it looks strange.
The bit that connects to the nozzle doesn't seem to be at a 90 deg angle to the rest. Is this normal? Sitting like this makes nozzle sit at an angle into the hopup, also makes it rub on the cylider head nozzle.

Thx
Vortex

[madwelshman]

Re: v3 Tappet Plate Issue

should be 90degs! causes all sorts of air seal issues, and feed issues

[Lee 303]

Re: v3 Tappet Plate Issue

If it is not 90 degrees to the rest of the then could you measure or guestimate the angle ??????

[vortex]

Re: v3 Tappet Plate Issue

Hi,

Here's a Pic.
As you can see its far from 90deg!


Vortex

[SAS Scott]

Re: v3 Tappet Plate Issue

I had a tappet plate like this it was the cause of my feeding issues .
I have seen some V3 tappet plates (after market psem for one) which are not perfectly 90 degrees but it still worked fine and that tappet plate you got there looks fine.Its not far off 90 degrees.

[vortex]

Re: v3 Tappet Plate Issue

Thanks for the help.

Its going back from where it came! not happy putting somthing thats defective in my aug.
Infact after looking at another systema tappet plate I have laying around, it has the same issue! Won't be using systema tappet plates ever again.

Vortex