Tm mp7a1 gbb - hop unit and barrel

[Creedy]

Has anyone removed these yet?

Can figure I out yet no don't want to break it

[Creedy]

Re: Tm mp7a1 gbb - hop unit and barrel

Done it.

It comes apart pretty much the same as the kwa model, there is a few YouTube videos showing how to do that.

[Andrew March]

Re: Tm mp7a1 gbb - hop unit and barrel

Bear in mind that if you do break anything TM parts are thin on the ground at the moment and you can't order direct from them, it has to be through a retailer.

[Creedy]

Re: Tm mp7a1 gbb - hop unit and barrel

After taking it apart there isn't anything that you could break, but the tiny screws could go missing if not carefull.

[Stormshaddow]

Re: Tm mp7a1 gbb - hop unit and barrel

I've recently taken mine apart, when you get to the hop unit, theres the adjustment arm, a plastic block which has a fin either side that applies the pressure and the actual hop rubber - a standard vsr/tm glock type bucking, but no hop nub, is this right, as the bucking seems to be getting more crushed than depressed by the plastic part with the fins on.! :S did yours have a ballbearing or a rubber nub like the kwa or a standard aeg hop unit?

[Creedy]

Re: Tm mp7a1 gbb - hop unit and barrel

I can't remember sorry.

I'm sure it's just like a tm pistol or vsr and its just the arm that applies hop up