TM revolver triple feeding

[skapunkninja]

Good evening all

I have a Marui M19 revolver with a feed issue. It was dropped, and since then it will fire all the BBs in the chamber in one shot, rather than one BB at a time. This happens on all 6 chambers.
If i load just one BB into each it fires perfectly, so i dont think its a hop/ alignment problem.

Anyone got any ideas?

[heroshark]

Re: TM revolver triple feeding

Swing out the cylinder and squeeze the trigger. The bit that the channels the gas into the shell should move forward and stay forward when the trigger is fully depressed. If not that's your problem.

[skapunkninja]

Re: TM revolver triple feeding

i think ive figured it out...

when the trigger is pulled, the black rod in the photo is supposed to move up and push the silver part up then hold it in place.
Rather than hold it in place though, its sliding over it and allowing the gas nozzle to move.


now just to figure out why...

EDIT - figured it, part of the casing which hold the arm in place has broken off :/