TM MK23 mags - leaking majorly

[badas]

the bottom O rings are leaking that bad they won't accept any gas.....

how do i dismantle the mag fully so i can oil it all up properly and grease the seals again ?

i can see 2 pins that i can take out, but the base is still secured

ty

[MantisCorp]

Re: TM MK23 mags - leaking majorly

That's because the mags aren't designed to be stripped easily. On one side you'll see a third blanking pin that doesn't go right through. You need to use a 2mm drill to drill it out (to about 3 mm deep) and the base will come off. However it's not going to be the seal that is away, but more likely the pressure release valve on the other side. It's there to stop you over pressurising the magazine. Remove the release valve, fill the hole with epoxy and let to set. Now regrease and rebuild your magazine and if everything works, your mag will be leak free.