Kong power burst wizard mosfet help

[mumbles]

I'm using one of these in my dmr build and for the life of me can't get it programmed how I want.
I'm after semi auto staying as is and full auto being either 1 second delay or semi.
Basically no full auto to use as dmr with appropriate fps etc.
Any help from someone with knowledge of these units would be great.
I have the instructions just can't seem to figure it out
Cheers, mumbles.

[dadio]

Re: Kong power burst wizard mosfet help

firstly you need to have it wired in to use that function not just plug and play , so assuming you have soldered it in with the additional wire you have to plug in the battery , once the battery is plugged in you have to go through the set up procedure on the instructions to the point that you can adjust the delay between burst fire (in you'r case set to a burst of one) and auto ,this gap of time can be set in 0.25 second increments so 4 pulls of the trigger for one second , i have never try'd to then get another single shot at this point so it would then fire in auto but it would mean you have a hole second to take your finger off the trigger before that happened. if you have lost the instructions you can download them or if you are desperate i could dig out my copy and scan it for you.

[sigee]

Re: Kong power burst wizard mosfet help

I just disabled resume full auto and set the burst count to 1.

[mumbles]

Re: Kong power burst wizard mosfet help

Cheers guys
Will hard wire it in and go from there