Mag problems

[Cayuse]

Got a x3 set of M4 mags and they dont clip in properly so u can pull them out without pressing the releast button.
Any tips of solving this?

Cheers

[Barny Hamon]

Re: Mag problems

What make are they? If they're metal you may find that bending the cut-out on the outer shell of the mag out a little bit (1 or 2mm) can make them stay in and feed. I've never tried it but iv'e heard it reccommended.

[Cayuse]

Re: Mag problems

they are d boys and going into a A&k, Yea was just thinknig the same actually not sure how easy it would be to do though. Any other ideas?

[Barny Hamon]

Re: Mag problems

Electrical tape wrapped around the mag itself? Have you thought about getting some A&K ones? If you have some longnose pliers its very easy.

[Cayuse]

Re: Mag problems

No i couldnt find any A&k mags on the net.
Ok ill give it a wurl.

[Cayuse]

Re: Mag problems

hmm ive got the mag to stay in buy cutting that square but it doesnt seem to release the little switch to allow the bbs to go inside the hop?

[Destroyer]

Re: Mag problems

some mags hate some guns..... this is a fact of life. like, my ics m4, doesnt like ics mags?!?!

[Cayuse]

Re: Mag problems

Yea i know i use to have problems with CYMA mp5's,
In that case does people know what the A&K M4's will take?
Or a link to some new A&k M4 mags? As in searches i can only find AK mags

[Brisingr!]

Re: Mag problems

pmed with some help.

I couldn't post it here because the link isnt to Zero-one!