thread sizing 14mm ?

[bob86]

Re: thread sizing 14mm ?

then its a die nut, should also be hex sided not round?

usually, if it isnt a die nut, it'll be split, and will be round

[No1_sonuk]

Re: thread sizing 14mm ?

Nope. It's a full die, round, and not split.

This is what the Left hand one I have looks like (I may have got it from here) - the right hand one looks the same.
http://www.ebay.co.uk/itm/14mm-14-x-...item2566c0404a

[bob86]

Re: thread sizing 14mm ?

ok, i stand corrected

[thekonassure]

Re: thread sizing 14mm ?

Yep I got this one http://www.ebay.co.uk/itm/1707653833...#ht_1035wt_698

and I think I said vice and grips I`m sure my vice can close up a die pretty easy even if it was a split die and I have a stock somewhere or I can just make one a big nut drll a few holes in it and tap a few bolts into it ain`t too hard if I can`t be bothered to go see my old engine building friends lol