Rail Problems!

[Jack.Murnin]

Hello, I have a Maurzen L96, which came with a Picatinny Rail, which means the scope I purchased. I was wondering if there is any way I can make the scope fit or will I just try and get a flat rail?

Thanks, Jack

PS. A M4 ACOG Fits the Rail

[blytm]

Re: Rail Problems!

Then adjust the scope rings? Would that work?

[Boo-Sabum Ben]

No it'll be the height of the clamps rather than the width. Just get a new mount. £15 at most

[Jack.Murnin]

Re: Rail Problems!

Then adjust the scope rings? Would that work?

Its the actual part where the bolts are located. An angled piece of metal goes on at one time, the bots go across, it gets sandwiched on the rail by another angle peice of metal, which the bolts come through and a nut is put on the end. These angled bits of metal are actually to shallow for the rain as it seems to be too tall. If I took a bit off the top with a file, would this work?

Thanks, Jack

[Jack.Murnin]

Re: Rail Problems!

No it'll be the height of the clamps rather than the width. Just get a new mount. £15 at most

Thanks dude. Does the main site sell them on here?

[blytm]

Re: Rail Problems!

Ah http://www.zerooneairsoft.com/ have a look then chap.

[Jack.Murnin]

Re: Rail Problems!

Ah http://www.zerooneairsoft.com/ have a look then chap.

Will do, Cheers!