CM16 SR-XL loose stock/buffer tube

[Chazmo]

SO I've got a G&G CM16 SR-XL and the stock and buffer tube have become very loose and wobbly after about only 3 skirmishes. Is there a way I can tighten them up again?

Thanks, all help is very much appreciated.

[Mintsauce5]

Re: CM16 SR-XL loose stock/buffer tube

There's a bolt if you look down you buffer tube probably just needs tightening up , be careful though as I think your mosfet is located in the buffer tube

[Caldymoose]

Re: CM16 SR-XL loose stock/buffer tube

Either your castle nut has come loose (the big nut on the outside of your buffer tube which has the pattern of a castle wall on it) or there is a bolt/screw inside the buffer tube which screws into the back of your gearbox. You will need a long screwdriver to get to it though. Just be careful not to pinch a wire in there!

[colinjallen]

Re: CM16 SR-XL loose stock/buffer tube

On the CM16 SR it is just a screw inside the buffer tube. Pop the stock open, have a look down inside and you will see it. Carefully tighten up the screw without damaging any of the electric gubbins.

[sparrowhawk]

Re: CM16 SR-XL loose stock/buffer tube

It's gonna be a Philips headed screwdriver